THIS IS A SIMPLE SOLUTION
TO A VERY COSTLY PROBLEM

NO VALVE REMOVAL

NO BREAKING INTO TANKS

NO DESTROYED THREADS

NO WELDING


DEVELOPED BY THE INVENTOR OF THE ARCTIC BLASTER THAWING DEVICE

AND THEY WORK!!


Arctic Valve Heaters
The Simple Solution to a Difficult Problem

We have manufactured these valve heaters to simplify the installation and the use of valve heaters. Arctic valve heaters are made so that you can install them yourself simply and quickly.

The 3" and 4" heaters are made so that you remove the top of the M and Z valves. The bracket that holds them on are then fitted to the valve with about ¼" space below the bracket. The valve top is then reinstalled and screws are reinstalled. Sometimes the bracket may have to be bent slightly to get screws in and the heater fitted as tight as possible. The glycol lines are hooked into the system behind the cab heater with two independent valves. They are installed carefully inside the frame rails and protected by split wire loom if possible. Hook up heaters in series without any T connections if possible. The six inch valve heaters are simply installed on the top of the valves without removing all the screws.

The Betts Heaters are made extremely tightly and can be installed to the valves using silicon or welding if your valves are new or removed from the truck (fire protection). These heaters were designed and manufactured by someone with 35 years of pumper truck experience. We are quite confident that they will solve most of your problems. In really cold conditions they can be installed with foil wrapped fibreglass insulation.


4" Betts Valve Heater


6" Betts Valve Heater


3" Valve Heater


4" Valve Heater


6" MZ Lever Valve Heater


6" Piston Style (Old Style)


6" Piston Style (New Style)
click here to go to the main page